ARTISTIC Not Available USER.eab4a435-2661-4523-9ca2-f2d2340a461c Invisible Zipper Foot #4126870-45 for Husqvarna Viking group 1,2,3,4,5,6,7 Does not apply
Returns Accepted Safe and secure paymentsSafe and secure payments. 100% Satisfaction Guaranteed
Invisible Zipper Foot #4126870-45 for Husqvarna Viking group 1,2,3,4,5,6,7

Invisible Zipper Foot #4126870-45 for Husqvarna Viking group 1,2,3,4,5,6,7

$9.97 (2% off)
About this Item
Available stock:17
Location: Northridge, California

Returns: Accepted
Condition: New
About the Seller
Shipping Handling time and Shipping policy

Brand : [ARTISTIC]
UPC : [Does not apply]
Item Specifics
Viking Husqvarna 3 Groove Pin Tuck w/ Raised Seam Foot 4128456-45 Fits1-7 Model       
This is not manufactured by Viking Husqvarna

how to use:

An invisible zipper is always inserted before stitching the garments seam. The Invisible Zipper  Foot has two grooves underneath the foot to accommodate the zipper coils and hold them in place as you stitch. Buy a zipper that is at least 1 1/4" (3 cm) longer than the zipper opening.

1. Mark the length of the zipper opening on the seam allowance and on the zipper. The excess length should be at the bottom of the zipper.

2. Snap on the Invisible Zipper Foot. Select center needle position straight stitch. Length 2.5 - 3.0.
3. Unzip the zipper.
4. Place the right part of the zipper on the fabric right sides together. The coil should be on the seamline and the top stop of the zipper 3/4" (2 cm) below the cut edge of the fabric. (Illustration A)
5. Fingerpress up the zipper coils and lower the presser foot with the zipper coils in the right opening under the foot. (Illustration B)
6. Adjust needle position to align the needle with the needle guide on the front of the foot. Backstitch and sew. Stop at the mark on the zipper and seam allowance and backstitch to tie off. (Illustration C)
7. Place the left part of the zipper right sides together with the left side of the garment. Lower the presser foot with the left opening over the zipper teeth. Make sure that the needle is perfectly aligned with the needle guide in front of the foot again. Sew in the same way as the first side.
8. Pull up the zipper pull. Place the fabric with the zipper right sides together. Snap on the regular Zipper Foot to the left of the needle. Adjust needle position to the right. Start stitching in the backstitched seam and sew the seam below the zipper. (Illustration D
If the zipper is too long, whipstitch across the zipper teeth 1 1/4" (3 cm) below the inserted zipper length. Cut away excess zipper below the whipstitching.

Guaranteed to fit Husqvarna Viking Sewing Machine Models:

Group 7 Models: Designer SE, Designer I USB, Designer I ESS, Designer I, Quilt Designer II, Designer II, Quilt Designer, Designer Diamond, Designer Jade 35, Designer Ruby Royale, Designer Topaz 20, Designer Topaz 30, Designer Topaz 50, Designer SE, Designer SE, Limited Edition, Designer I, II, Quilt, Designer, Quilt Designer II, Opal 690Q, Opal 670, Sapphire 875Q, Sapphire 870, Sapphire 855, Sapphire 850, Sapphire 835, Sapphire 830, Sapphire 930, Sapphire 960Q, Tribute 145C

Group 6 Models: Platinum 955 E, 950 E, Platinum Plus, Platinum 770, 775, Platinum 750 Quilt, 755 Quilt, Platinum 730, 735, Platinum 715, Rose 600, 605, Iris, Scandinavia 300, 200, Interlude 445, 435, Lily 555, 550, 545, 540, 535, 530, 500, Freesia 445, 435, 425, 415, Lisa, Angelica, Viva, Victoria, 500, Facette 500/400, Emerald, 203, 183

Group 5 Models: Emerald 116, 118, 122, Prelude 340, 360, 350, 370, Scandinavia 100, Daisy 335, 330, 325, 320, 315, 310, Oscar, Sophia, Emma, Lena, Romeo, Juliet, Anna, Sarah, 250, 230, 225/215, 210, 205, Jeans, Hugin, Tribute 145M

Group 4 Models: Classica 105, 100, 95, 90

Group 3 Models: Optima 630, 620, 610, 190, 185, 180, 150, 120

Group 2 Models: Prisma 990 S, 990, 980, 960, 950 S, 950, 945, 940

Group 1 Models:Orchidea, 1250, #1, #1+, 1200, 1100, 1090, 1070, 1070 S, 1050

Group D Models: All 2000, 3000, 6000 series, 1010, 1030, 1040, 3010, 3310, 3610, 5610, 5710, 6570, 6690, 3240

  • Presser Foot Shank TypeSnap-On
  • Presser Foot TypeZipper Foot


Five Stars
Perfect for what I needed!
It works perfectly fine and snapped right on. Good value and well made (especially for two feet). Definitely recommended. This is a good deal for two presser feet. I faced no issue using them, plus it was easy to work with. The quality of the zipper is very good and is in a good condition.
Five Stars
Works very well
The zipper foot fits easily on a variety of machines and it glides through the clothes like a hot knife through butter! It is very good and it has made sowing so much easier for me!
Five Stars
Fits very well
The zipper foot fits really well. I am able to sow my seams and zippers very easily using this. It doesn't get caught in the fabric or miss out of stitches. I love this product and I swear by it for my sewing.
Truegether Logo
About This Item
Item Specification